Falco Flash BLE 1.8 app for iPhone and iPad

The app has the following functions:

Scanner Screen

Show list of all available Falco eDrives. after click on any one of them from list, we are connect to same falco eDrive.

Main Screen

Display speed in MPH or KPH, Battery Charge level (Minimum battery voltage should be 30V).
Total Duration of time for which Falco Flash has been connected to eDrive.
Display level of assistance
Assistance level can be increased by swapping the finger in the upward direction on the main screen (swap length should be more than 1 inch) once Hx motor is connected.
Do the same by swapping the finger downwards (swap length should be more than 1 inch) to decrease assistance level.
Connect and disconnect Falco Flash by using the single button on the main screen (White/blue round color button on the main screen-White for Start, Blue for Stop).

Emergency Stop can be activated by activating the Emergency Stop (Red Color) button on the main screen. Emergency Stop button will set the motor power level to -3.

Setting Screen
Motor ID Setting(You can see connected device id,also can set on the Falco eDrive through App)
Device Information (Displays Firmware Number and Turn On Voltage)
CRM Setting(Circumference setting )
Battery Selection

eDrive Data Screen
Displays following parameters
Voltage (V)
Current (A)
iWatts (Instantaneous Power )
Battery Capacity(Wh)
WH Consumed
WH Remaining
Watt Hour/KM
KM/Miles Range remaining
Temperature /Level (Power Level)
H Sensor Error

Torque Sensor Setting
App has the same motor control capability as the PC and MAC version. Torque sensor and individual power level adjustments are added.


Power Configurator
Screen allows Current clamp setting on different power level through Assist /Regen Mode.